So… A run down of how to set up a Sound Mix for a ship…
A couple of things to remember… You have to realise that most of the people aboard would be over the age of 50... This makes for a little adjustment of how you approach the console and the show. You have to remember that most peoples hearing deteriorates over time, and even if you do feel the need to pump up the bass in a venue (as we all want to do with a rocking show) it is not such a good idea. Older people have an especially low tolerance for bass (which they perceive as loud) and Mid freqs tend to hit them even harder. So it would be a good idea to go and have a look at what the mix needs most. I have found that a solid mix driven with a kick, a little Bass and keys does the trick. Ad lets face it, on ships most guitar parts are actually not even really guitar parts, but more a derivative of what the horns play. I haven’t worked with a lot of guitar players on a ship where they actually are able to play guitar with a little bit of feel and improv.
Next up would be the microphone choice. Now I know that most people would immediately go ‘58s work’ but go and play around a bit. I once ran a show where I had 4 vocalists, and I must say that what worked best for me was actually giving one of the singers an 87. I was lucky to have quite a few of the suckers lying around, but I did listen closely to the vocalists when I did my pre show talk with them before I gave them a mic. This was probably most beneficial when I worked with a certain act who was notorious throughout the fleet about having loud levels on stage and who wanted everything as loud as possible. I figured out by the way he was turning his head towards me whilst speaking that he was deaf in one ear (well, almost) and so I took a 87 (everyone gave him 58s), and played around with the monitor EQ for him. This proved magical, and also made a fleet wide record for a sound check for him on an analogue console. The normal rehearsal would normally take 3-4 hours with him constantly adjusting things that made no sense at all, but I got it down to 45minutes, including the band playing through the music. So yes, its possible… Apparently the fleet record is 35minutes, they however cheated ;-) they had a digico D5 to their disposal.
OK.. Lets move to another act. This consisted of 4 gents singing old school rock and roll. With one of the singers doing some noodling on his Fender. Firstly I had to get them all actually hearing themselves on stage, so there were 4 wedges for them, each with their own send (yes, you sometimes do have the luxury of having a load of Aux sends), and no, there is no dedicated monitor engineer with console onboard. For our production shows we also run overhead monitors to keep sightlines clean, and so I also used those suckers. Creating a bit of warmth for them and also trying to keep stage levels lowish. This I also managed by pulling all the amps off of the stage. The Bass amp was on stage facing into the wing next to the bassist. The Orchestra guitarist’s amp was in the wing on its angle legs facing up at him, also playing across the stage. The special acts guitar was also in the wing, just behind the main curtains drop facing across stage. I just gave him a bit of guitars in his monitor.
The vocals were a combination of 58s and 87s, esp. the lead vocalist was on an 87 to bring out a bit of air in his vox, and to stop the congestion that 58s cause.
What other acts… Well, the production shows always proved to be a problem. See, there are no real floor wedges and side fills in the wings, but only the overheads. And because the orchestra is sitting in the pit right in front of them they were being blasted by that and also the need for backtracks in the monitors. So it took a lot of effort to try and get it just right. I actually despise working on those production shows, because of the inconsistency of the singers on nights. But there are ways around that. They didn’t want comps on their vocals, well, sorry to hear that. They had very little compression on their main vocals, but on my group send I had a tube comp cleaning them up and making them all more punchy combined with an EQ on that group as well for FOH purposes. FX was my main toy, and trying to keep the girls from screeching the ears off of the audience I would ride that reverb hard… It just drenched the problem. Well, you’d say that I could ride the group, and I did, actually quite a lot, but sometimes you need the punch and there you had to play around with the various tricks to your disposal.
Another thing in the house to try and make things a little better was to get the delay stacks to work just right. Now there are various ways to do it. My favourite was to play music through the mains and then walk around with a DB meter. And then try and match the DB level from the main PA all around the venue to what it is 10 rows back from the front of the stage. Other than that I would just walk around during the rehearsals and have a look at what the venue did for me for that particular act.
No comments:
Post a Comment